Tuesday, Sep 29, 2020

September 29, 2020

September 2020

Panel 1
Greg: Well, what do you think?
Liz: That right there is some DAMNED fine millwork! Thank you, sweetie!

Panel 2
Greg: So unfortunately, the only router bits I could find that had the proper profile for windowsills had a ½” shank, and the router I was using only went up to ¼”, so I had to get a new router to do the job.
Liz: Oh. Well, I mean, that’s a bummer, but it is what it is.

Panel 3
Greg: I also had to get some additional accessories to get it to fit to the router table… and another edge bit for the bottom of the apron.
Liz: At least the cost will spread out a bit if we do more than just the one windowsill, right?

Panel 4
Greg: Yeah! As long as we do all the windows in the house.
Greg: ...and every other house in the neighborhood.